Safety Reset
In the event of the detection of a fault (AC/DC Leakage, Earth Fault etc) the charger will lock and prevent charging. In such an event, the cause of the fault should be fully investigated by a qualified electrician, after which the charger can be reset as follows:
1
The charger indicates that a fault has been detected by displaying the buttons in red. See the error state table to identify the exact fault.
2
To reset, press and hold the Start / Stop button for 5 seconds to reset the charger. If the charger buttons return to red, the fault persists.
Error States
A/C D/C Leakage
Overcurrent
PEN Fault
Relay Welded
CP Error
Ventilation Error
Fully Investigate any Fault to Prevent Future damage to your equipment.